About seller
No mechanical vulnerability of ascending thoracic aortic aneurysms was evidenced in bicuspid aortic valve patients, corroborating present conservative guidelines concerning the management of bicuspid aortopathy. Weakening and additional vulnerability was evidenced in aged patients and those with coexisting valve pathology, aortic root dilatation, hypertension, and hyperlipidemia. Discussion of these results from age- and sex-matched subjects, accounting for the region- and layer-specific aortic heterogeneity, in relation to intact wall results and histologic confirmation, helps to reconcile previous findings and affords a universal interpretation of ascending aorta mechanics in bicuspid aortopathy.Reported here are two unprecedented copper-rich open-framework chalcogenides constructed from unusual [Cu5(SnxM1-x)Se10] clusters and [(SnxM1-x)2Se6] dimeric linkers (M = In and Ga). The photoresponsive properties in the IR range and the photocatalytic activity for degradation of methylene blue dye of these two isostructural semiconductors were proved to be effectively adjusted by trivalent metal ions in a cluster.Electromechanical actuators with toxic lead-based electrostrictive materials dominate the market of high-precision electronics devices, so one of urgent aims becomes how to explore the new generation of ecofriendly electrostrictive materials with superior electrostriction behaviors. Herein, a strategy of modifying the active space for the B-site in lead-free relaxor ferroelectrics arouses the potential capacity of electrostriction, including K0.5Na0.5NbO3 (KNN). Through co-doping of Bi3+ and Ni2+, typical relaxor ferroelectrics (1 - x)K0.5Na0.5NbO3-xBiNi2/3Nb1/3O3 (KNN-xBNN, 0.03 ≤ x ≤ 0.07) are constructed because of the incorporation of dopants ions on the A- or B-site promotes structural disorder. Importantly, a limited active space for the B-site is obtained owing to the contracted oxygen-octahedron with smaller A-site dopants induced by lattice distortion. Benefiting from the design strategy, a remarkable enhancement of electrostrictive coefficient Q33 of ∼0.0456 m4/C2 is achieved, which is higher than those of KNN-based materials and also twice as large as those of lead based materials. The Q33 also exhibits a relatively good electric field and is temperature-independent. A giant Q33 of 0.0512 m4/C2 is gained at a high frequency of 100 Hz, meeting the requirement of some commercial actuators for fuel injectors. Such a strategy may help us design high-performance electrostrictive materials.A material with anisotropic heat conduction characteristics, which is determined by molecular scale structure, provides a way of controlling heat flow in nanoscale spaces. As such, here, we consider layer-by-layer (LbL) membranes, which are an electrostatic assembly of polyelectrolyte multilayers and are expected to have different heat conduction characteristics between cross-plane and in-plane directions. We constructed models of a poly(acrylic acid)/polyethylenimine (PAA/PEI) LbL membrane sandwiched by charged solid walls and investigated their anisotropic heat conduction using molecular dynamics simulations. In the cross-plane direction, the thermal boundary resistance between the solid wall and the LbL membrane and that between the constituent PAA and PEI layers decrease with increasing degree of ionization (solid surface charge density and the number of electric charges per PAA/PEI molecule). When the degree of ionization is low, the cross-plane thermal conductivity of a constituent layer is higher than that of the bulk state. As the degree of ionization increases, however, the cross-plane thermal conductivity of PAA, a linear polymer, decreases because of the increase in the number of in-plane oriented polymer chains. In the in-plane direction, we investigated the heat conduction of each layer and found the enhancement of effective in-plane thermal conductivity again due to the in-plane oriented chain alignment. The heat conduction in the LbL membrane is three-dimensionally enhanced compared to those in the bulk states of the constituent polymers because of the electrostatic interactions in the cross-plane direction and the molecular alignment in the in-plane direction.The combination of organic and inorganic materials at the nanoscale to form functional hybrid structures is a powerful strategy to develop novel electronic devices. The knowledge on semiconductor thin-film polarization brings direct benefits to the hybrid organic/inorganic electronics, becoming primordial for the development of devices such as electromechanical logic gates, solar cells, miniaturized valves, organic diodes, and molecular supercapacitors, among others. Here, we report on the dielectric polarization of ultrathin organic semiconducting films-ca. 5 nm thick metal phthalocyanine ensembles (viz., CuPc, CoPc, F16CuPc)-employed to build up hybrid metal/oxide/molecule heterojunctions. Such hybrid heterostructures are fully integrated into self-rolled nanomembrane-based capacitors and further investigated by impedance spectroscopy measurements as a function of temperature (from 6 to 300 K). The dielectric polarization of the metal phthalocyanines is found to be thermally activated above a specific threshold temperature, which depends on the molecular structure. see more Below this threshold, the current leakage across the system is suppressed, thus evidencing intrinsic-like polarization mechanisms. The temperature-independent permittivities of the ultrathin molecular films are found to be strongly dependent on the organic/inorganic hybrid interfaces, while the calculated relaxation times are more likely related to each single-molecule polarization. Beyond the advances in determining the temperature dependence of the permittivity for ultrathin phthalocyanine films integrated within solid-state electronics, our results also support the deterministic design of novel functional devices based on nanoscale hybrid organic/inorganic heterojunctions.An energy decomposition analysis is developed for the three-body expansion of the fragment molecular orbital method at the level of density functional theory, density-functional tight-binding, coupled cluster, and other quantum-mechanical approaches in vacuum and solution. It is shown that the addition of three-body terms improves the accuracy of the components and the total energies. For a compact representation, three-body corrections can be incorporated into two-body interactions to reduce the complexity of the analysis. The method is applied to solvated alkali and halide ions, a nanocrystal of ice, and a Trp-cage protein (PDB 1L2Y)-ligand complex.