This article reports on a noninvasive approach in detecting and following-up individuals who are at-risk or have an existing COVID-19 infection, with a potential ability to serve as an epidemic control tool. The proposed method uses a developed breath device composed of a nanomaterial-based hybrid sensor array with multiplexed detection capabilities that can detect disease-specific biomarkers from exhaled breath, thus enabling rapid and accurate diagnosis. An exploratory clinical study with this approach was examined in Wuhan, China, during March 2020. The study cohort included 49 confirmed COVID-19 patients, 58 healthy controls, and 33 non-COVID lung infection controls. When applicable, positive COVID-19 patients were sampled twice during the active disease and after recovery. Discriminant analysis of the obtained signals from the nanomaterial-based sensors achieved very good test discriminations between the different groups. The training and test set data exhibited respectively 94% and 76% accuracy in differentiating patients from controls as well as 90% and 95% accuracy in differentiating between patients with COVID-19 and patients with other lung infections. While further validation studies are needed, the results may serve as a base for technology that would lead to a reduction in the number of unneeded confirmatory tests and lower the burden on hospitals, while allowing individuals a screening solution that can be performed in PoC facilities. The proposed method can be considered as a platform that could be applied for any other disease infection with proper modifications to the artificial intelligence and would therefore be available to serve as a diagnostic tool in case of a new disease outbreak.Various electrolyte components have been investigated with the aim of improving the cycle life of lithium-oxygen (Li-O2) batteries. A tetraglyme-based electrolyte containing dual anions of Br- and NO3- is a promising electrolyte system in which the cell voltage during charging is reduced because of the redox-mediator function of the Br-/Br3- and NO2-/NO2 couples, while the Li-metal anode is protected by Li2O formed via the reaction between Li metal and NO3-. To maximize the potential of this system, the fundamental factors that limit the cycle life should be clarified. In the present work, we used nondestructive electrochemical impedance spectroscopy to analyze the temporal change of the charge transfer resistances during cycles of Li-O2 batteries with dual anions. The charge transfer resistance at the cathode was revealed to exhibit good correlation with the reduction of the discharge voltage. These results, combined with the results of electrode surface inspections, revealed that irreversible accumulation of insulating deposits such as Li2O2 and Li2CO3 on the cathode surface was a major cause of the short cycle life. Furthermore, the analyses of the time course of the solution resistance suggested that diminished reactivity between the redox mediators and Li2O2 was a critical factor that led to the irreversible accumulation of the less-reactive Li2O2 on the cathode and eventually to a shortened cycle life. Crenolanib These findings indicated that increasing the reactivity between Br3- and Li2O2 is essentially important for improving the cycle stability of Li-O2 batteries and the reactivity can be nondestructively assessed by tracking the dynamic changes in the solution resistance.Controlled buckling and delamination of thin films on a compliant substrate has attracted much attention for applications ranging from micro/nanofabrication to flexible and stretchable electronics to bioengineering. Here, a highly conductive and stretchable conductor is fabricated by attaching a polymer composite film (with a thin layer of silver nanowires embedded below the surface of the polymer matrix) on top of a prestretched elastomer substrate followed with releasing the prestrain. A partially delaminated wavy geometry of the polymer film is created. During the evolution of the buckle-delamination, the blisters pop-up randomly but self-adjust into a uniform distribution, which effectively reduces the local strain in the silver nanowires. The resistance change of the conductor is less than 3% with the applied strain up to 100%. A theoretical model on the buckle-delamination structure is developed to predict the geometrical evolution, which agrees well with experimental observation. Finally, an integrated silver nanowire/elastomer sensing module and a stretchable thermochromic device are developed to demonstrate the utility of the stretchable conductor. This work highlights the important relevance of mechanics-based design in nanomaterial-enabled stretchable devices.G protein-coupled receptors (GPCRs) transduce extracellular signals into cells by interacting with G proteins and arrestins. Emerging evidence suggests that GPCRs on the plasma membrane are in a dynamic equilibrium among monomers, dimers, and larger oligomers. Nevertheless, the role of the oligomer formation in the GPCR signal transduction remains unclear. Using multicolor single-molecule live-cell imaging, we show a dynamic interconversion between small and large oligomer states of a chemoattractant GPCR, Formyl Peptide Receptor 1 (FPR1), and its binding affinity with G protein. Full agonist stimulation increased a fraction of large FPR1 oligomers, which allowed for prolonged FPR1-G protein interaction. The G protein interaction with FPR1 was most stabilized at the full agonist-bound large FPR1 oligomers. Based on these results, we propose that G protein-mediated signal transduction may be regulated synergistically by the ligand-binding and FPR1 oligomerization. Cooperative signal control induced by receptor oligomerization is anticipated as a target for drug discovery.Liposomes have proven to be effective nanocarriers due to their ability to encapsulate and deliver a wide variety of therapeutic cargo. A key goal of liposome research is to enhance control over content release at diseased sites. Though a number of stimuli have been explored for triggering liposomal release, reactive oxygen species (ROS), which have received significantly less attention, provide excellent targets due to their key roles in biology and overabundance in diseased cells. Here, we report a ROS-responsive liposome platform through the inclusion of lipid 1 bearing a boronate ester headgroup and a quinone-methide (QM) generating self-immolative linker attached onto a dioleoylphosphatidylethanolamine (DOPE) lipid scaffold. Fluorescence-based dye release assays validated that this system enables release of both hydrophobic and hydrophilic contents upon hydrogen peroxide (H2O2) addition. Details of the release process were carefully studied, and data showed that oxidative removal of the boronate headgroup is sufficient to result in hydrophobic content release, while production of DOPE is needed for hydrophilic cargo leakage.