Simulation results show that a classification accuracy over 93% can be achieved, which can be considered good for this complex problem. Gastrointestinal stromal tumors (GISTs) are mesenchymal tumors and have some malignant potential. Mitotic count is important for predicting the malignant potential of GISTs. Proper treatment of GISTs requires accurate pathological diagnosis. In general, endoscopic ultrasound-guided fine-needle aspiration and deep biopsy are used for pathological diagnosis of GIST before making decisions about surgery. This study sought to evaluate the pathological uniformity of gastric GISTs for mitotic index of the center and periphery of the GIST. We retrospectively reviewed the data of 37 gastric GIST patients who underwent wedge resection at Hanyang University Hospital. We used Armed Forces Institute of Pathology criteria to classify gastric GISTs. To determine the pathological uniformity of gastric GISTs, we compared GIST risk stratification between the center and periphery of GISTs. The mean size of GISTs was 3.56 ± 2.10 cm. Three lesions were located in the antrum, 11 in the fundus, 9 in the cardia, and 14 in the body. The mean age of patients was 58.65 ± 9.44 years; 18 patients were male and 19 were female. Entinostat Thirty-five patients (94.6%) showed the same level of risk stratification between the center and periphery of gastric GISTs, while two patients (5.4%) presented different levels of risk between the two sites. No significant difference in mitotic count was observed between the two sites (kappa value = 0.863; = 0.001). Mitotic index category (either more than five mitoses per high-power field or five or fewer mitoses per high-power field) of GISTs showed good concurrence between the center and periphery.Mitotic index category (either more than five mitoses per high-power field or five or fewer mitoses per high-power field) of GISTs showed good concurrence between the center and periphery.Equitable access to healthcare services is a major concern among immigrant women. Thus, this study investigated the relationship between socioeconomic characteristics and healthcare needs among immigrant women in Taiwan. The secondary data was obtained from "Survey of Foreign and Chinese Spouses' Living Requirements, 2008," which was administered to 5848 immigrant women by the Ministry of the Interior, Taiwan. Additionally, descriptive statistics and significance tests were used to analyze the data, after which the association rule mining algorithm was applied to determine the relationship between socioeconomic characteristics and healthcare needs. According to the findings, the top three healthcare needs were providing medical allowances (52.53%), child health checkups (16.74%), and parental knowledge and pre- and post-natal guidance (8.31%). Based on the association analysis, the main barrier to the women's healthcare needs was "financial pressure." This study also found that nationality, socioeconomic status, and duration of residence were associated with such needs, while health inequality among aged immigrant women was due to economic and physical factors. Finally, the association analysis found that the women's healthcare problems included economic, socio-cultural, and gender weakness, while "economic inequality" and "women's health" were interrelated. Despite high-intensity lipid-lowering therapy, there is a residual risk of cardiovascular events that could be associated with lipoprotein(a) (Lp(a)). It has been shown that there is an association between elevated Lp(a) level and cardiovascular outcomes in patients with coronary heart disease. Data about the role of Lp(a) in the development of cardiovascular events after peripheral revascularization are scarce. To evaluate the relationship of Lp(a) level with cardiovascular outcomes after revascularization of carotid and lower limbs arteries. The study included 258 patients (209 men, mean age 67 years) with severe carotid and/or lower extremity artery disease, who underwent successful elective peripheral revascularization. The primary endpoint was the composite of nonfatal myocardial infarction, nonfatal stroke, or cardiovascular death. The secondary endpoint was the composite of primary endpoint and repeated revascularization. For 36-month follow-up, 29 (11%) primary and 128 (50%) secondary endpoints were registered. There was a greater risk of primary (21 (8%) vs. 8 (3%); hazard ratio (HR), 3.0; 95% confidence interval (CI) 1.5-6.3; < 0.01) and secondary endpoints (83 (32%) vs. 45 (17%), HR, 2.8; 95% CI 2.0-4.0; < 0.01) in patients with elevated Lp(a) level (≥30 mg/dL) compared to patients with Lp(a) < 30 mg/dL. Multivariable-adjusted Cox regression analysis revealed that Lp(a) was independently associated with the incidence of cardiovascular outcomes. Patients with peripheral artery diseases have a high risk of cardiovascular events. Lp(a) level above 30 mg/dL is significantly and independently associated with cardiovascular events during 3-year follow-up after revascularization of carotid and lower limbs arteries.Patients with peripheral artery diseases have a high risk of cardiovascular events. Lp(a) level above 30 mg/dL is significantly and independently associated with cardiovascular events during 3-year follow-up after revascularization of carotid and lower limbs arteries.Ferro-coke, as a new burden of blast furnace (BF), can not only greatly reduce the energy consumption and CO2 emission, but also promote the resource utilization by using the low-quality iron ore and low-grade coal. However, the strength of ferro-coke decreased with the increasing amount of iron ore powder. In order to maintain the strength of ferro-coke while increasing the amount of iron ore powder, it is necessary to add binder during the coking process to enhance the strength of ferro-coke. In this paper, phenolic resin, silicon metal powder, corn starch, and coal tar pitch were used as binder for the fabrication of ferro-coke. I-type drum machine (I 600), scanning electron microscope (SEM), and X-ray diffraction (XRD) were applied to test the crushing strength, morphology, and microcrystalline structure of the ferro-coke. The results showed that the increasing amount of iron ore powder resulted in lower crushing strength, higher porosity, and the worse macroscopic morphology of ferro-coke. When the amount of iron ore powder reached 40%, obvious cracks appeared on the surface of ferro-coke.