The in vivo toxicity assay revealed that FEN-loaded Soluplus® micelle induced no severe toxicity. Therefore, we propose that preclinical and clinical safety and efficacy trials on FEN-loaded Soluplus® micelles would be worthwhile.The paper reports a joint experimental/theoretical study on the aging of reactive Al/CuO nanolaminates, investigating both structural modifications and combustion properties of aged systems. We first show theoretically that the long-term storage (over several decades) in ambient temperature marginally affects nanolaminates structural properties with an increase in an interfacial layer of only 0.3 nm after 30 years. Then, we observe that the first thermal aging step occurs after 14 days at 200 °C, which corresponds to the replacement of the natural Al/CuO interfaces by a proper ~11 nm thick amorphous alumina. We show that this aging step does impact the nanolaminates structure, leading, for thin bilayer thicknesses, to a substantial loss of the energetic reservoir considering a stoichiometric Al/CuO stack, the heat of reaction can be reduced by 6-40% depending on the bilayer thickness ranging from 150 nm (40%) to 1 µm (6%). The impact of such thermal aging (14 days at 200 °C) and interfacial modification on the initiation and combustion properties have been evaluated experimentally and theoretically. Varying Al to CuO ratio of nanolaminates from 1 to 3, we show that ignition time of aged systems does not increase over 10% at initiation power densities superior to 15 W·mm-2. In contrast, burn rate can be greatly impacted depending on the bilayer thickness annealing a stoichiometric nanolaminates with a bilayer thickness of 300 nm at 200 °C for 14 days lowers its burn rate by ~25%, whereas annealing a fuel rich nanolaminates with the same bilayer thickness under the same thermal conditions leads to a burn rate decrease of 20%. When bilayer thickness is greater than 500 nm, the burn rate is not really affected by the thermal aging. Finally, this paper also proposes a time-temperature diagram to perform accelerated thermal aging.Acute severe colitis is the major indication for surgery in inflammatory bowel diseases (IBD), and in particular, in ulcerative colitis (UC). A laparoscopic approach for abdominal colectomy is recommended, due to better perioperative and long-term outcomes. However, costs, time-spending, and outcomes are still a topic of improvement. We designed a standardized 10-steps, sequential approach to laparoscopic colectomy, based on the philosophy of the "critical view of safety", with the aim to improve perioperative outcomes (operative duration, estimated blood loss, complications, readmissions, reoperations, and length of postoperative stay). IL Receptor modulator We performed a retrospective cohort study using data from a prospectively maintained clinical database. We included all the consecutive, unselected patients undergoing laparoscopic subtotal colectomy (SCo) for IBD between 2008 and 2019 in a tertiary IBD Italian Centre. Starting from 2015, we regularly adopted the novel Sequential Approach for a Critical-View Colectomy (SACCo) technique. We included 59 (40.6%) patients treated with different laparoscopic approaches, and 86 patients (59.4%) operated on by the SACCo procedure. The mean operating time was significantly shorter for the SACCo group (144 vs. 224 min; p less then 0.0001). The SACCo technique presented a trend to fewer major complications (6.8% vs. 8.3%), less readmissions (2.3% vs. 13.5%; p = 0.01), and shorter postoperative hospital stay (7.2 vs. 8.8 days; p = 0.003). Laparoscopic SACCo-technique is a safe and reproducible surgical approach for acute severe colitis and may improve the outcomes of this demanding procedure.An RFID-based wireless system to measure the evolution of the setting process of cement-based materials is presented in this paper. The system consists of a wireless RFID temperature sensor that works embedded in concrete, and an external RFID reader that communicates with the embedded sensor to extract the temperature measurement conducted by the embedded sensor. Temperature time evolution is a well known proxy to monitor the setting process of concrete. The RFID sensor consisting of an UWB Bow Tie antenna with central frequency 868 MHz, matched to the EM4325 temperature chip through a T-match structure for embedded operation inside concrete is fully characterized. Results for measurements of the full set up conducted in a real-scenario are provided.Fish and seafood may play an important role for nutrition and food security as they contain essential vitamins, minerals, and essential fatty acids. The aim of this study was to describe the nutrient composition, including fatty acids, amino acids, vitamins, and minerals, in commonly consumed fish species (fillet- and whole fish samples) sampled off the Northwest African coast. Furthermore, we assessed the species' contributions to the recommended nutrient intake (RNI) values from the World Health Organization (WHO). Samples of commercially important fish species (Sardina pilchardus, Engraulis encrasicolus, Trachurus trachurus, Pagellus acarne) were collected using trawling on the R/V Dr. Fridtjof Nansen in May 2017 and analyzed for nutrients at the Institute of Marine Research as individual and composite samples. All the analyzed fish species were good dietary sources of several vitamins and minerals and whole fish were substantially more nutrient dense than fillet samples, especially with regard to vitamin A, iodine, zinc, calcium, and iron. Including 100 g of sardine or anchovy (whole fish) in the diet, would contribute substantially to the RNI for vitamin B12, vitamin D and vitamin A, EPA and DHA as well as the minerals iodine, zinc, and calcium. This study shows that fish consumed with skin, bone, and viscera may be very nutrient dense and important for local food and nutrition security.Fructose and glucose are commonly present together in mixtures and may need to be separated. Current separation methods for these isomers are complex and costly. Nanofiltration is a cost-effective method that has been widely used for separating carbohydrates of different sizes; however, it is not commonly used for such similar molecules. Here, we report the separation of fructose and glucose in a nanofiltration system in the presence of fructooligosaccharides (FOS). Experiments were performed using a pilot-scale filtration setup using a spiral wound nanofiltration membrane with molecular weight cutoff of 1 kDa. We observed three important factors that affected the separation (1) separation of monosaccharides only occurred in the presence of FOS and became more effective when FOS dominated the solution; (2) better separation was achieved when the monosaccharides were mainly fructose; and (3) the presence of salt improved the separation only moderately. The rejection ratio (Rf/Rg) in a fructose/glucose mixture is 0.